Samsung ht-410 Manuale Utente
16
15
CONNECTIONS
Press and hold DCDi button on the remote
control for over 3 seconds.
control for over 3 seconds.
•
Each time the button is pressed, the selection alternates between
DCDi ON
and
DCDi OFF
.
Converts the interlace signal to progressive to prevent flickering and to
remove distortion or noise on the edge of screen.
remove distortion or noise on the edge of screen.
DCDi
(Directional Correlational Deinterlacing)
Function
You can adjust the resolution switch to set the DVI and component (P
R
, P
B
, Y) output resolution to
576p(480p)/720p/1080i.
Example: If the TV supports resolution up to 576p(480p)
•
If you connect the DVI and Component outputs (P
R
, P
B
, Y) at the same time, Component output resolution changes
automatically to the designated DVI resolution.
Caution
Selecting Resolution
Set the resolution switch to 576p(480p).
•
A 576p(480p) video signal is output through the DVI
and component outputs (P
and component outputs (P
R
, P
B
, Y).
1
•
If copy protection is in place, output resolution is automatically converted to 576p(480p) when you play the
DVD, even if you set the resolution to 720p or 1080i.
DVD, even if you set the resolution to 720p or 1080i.
Note
Connecting the Video Out to TV
The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
normally. The cooling fan is activated automatically to supply cool air to the unit.
normally. The cooling fan is activated automatically to supply cool air to the unit.
Please observe the following cautions for your safety.
•
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
and may damage it.
•
Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit and fire may result.)
newspaper or cloth, heat may build up inside the unit and fire may result.)
Cooling Fan
Connecting the FM and AM Antennas
FM antenna connection
AM antenna connection
1. Connect the FM antenna supplied to the FM
75
Ω
COAXIAL terminal as a temporary mea-
sure.
2. Slowly move the antenna wire around until
you find a location where reception is good,
then fasten it to a wall or other rigid surface.
then fasten it to a wall or other rigid surface.
1. Connect the AM loop antenna supplied
to the AM and terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM ter-
minal. (Keep the AM loop antenna con-
nected).
minal. (Keep the AM loop antenna con-
nected).
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
slots of the base to assemble the
AM loop antenna.
FM Antenna (supplied)
AM Loop Antenna
(supplied)
(supplied)
If AM reception is poor, connect an
outdoor AM antenna(not supplied).
1p~40p(410HD)-GB 7/27/04 4:58 PM Page 18