Teltone m-392 Guida Utente
Remote Programming
Remember: the LSS will exit the programming mode and disconnect if 60 seconds elapse
without entry of any digits.
without entry of any digits.
Accessing the LSS through a Polling Controller
If remote programming is enabled, you can access the LSS for programming using a
Polling Controller, as well as a password. The Polling Controller instructs the LSS to
answer without ringing any of the device ports. Proceed as follows:
Polling Controller, as well as a password. The Polling Controller instructs the LSS to
answer without ringing any of the device ports. Proceed as follows:
Example of a Remote Programming Session
❑
Connect a DTMF telephone to the auxiliary port of the modem connected to the
Polling Controller, or unplug the modem connection to the Polling Controller and
replace it with a DTMF telephone.
Polling Controller, or unplug the modem connection to the Polling Controller and
replace it with a DTMF telephone.
❑
Dial the number of the LSS to be programmed and append #7 immediately after
the dialed number.
the dialed number.
❑
When the LSS recognizes the programming transfer code, you will hear 3 beeps.
Enter the password within 30 seconds. The default password is: 8358663#
Enter the password within 30 seconds. The default password is: 8358663#
Note:
Always terminate a password entry with #.
❑
When you hear a confirmation tone (3 short beeps), begin programming.
If an invalid password is entered, there will be no acknowledgment of any kind. The user
must hang up and wait for 30 seconds before attempting to re-enter the programming
access mode.
must hang up and wait for 30 seconds before attempting to re-enter the programming
access mode.
Caution: If three consecutive and invalid programming access attempts are made, the
LSS will lock out all further access for 1 hour. You cannot disable the Remote
Programming feature while in Remote Programming mode.
LSS will lock out all further access for 1 hour. You cannot disable the Remote
Programming feature while in Remote Programming mode.
❑
Enter
*
50#1# to set emergency priority. When you hear 3 beeps, you may enter
another command or exit programming mode. If you hear error tone, re-enter the
command.
command.
❑
Enter
*
51#1#911#911# to enter the number 911 as the first emergency priority
number. Listen for three beeps.
❑
Enter
*
51#2#18004263926#18004263926# to enter the number 1(800) 426-3926
as the second emergency priority number. Listen for three beeps.
❑
Enter
*
03#8378#8378# to change the password to “test” (8378). Listen for 3
beeps.
❑
Enter
*
06#4# to change the fax routing to Port 4. Listen for 3 beeps.
❑
Enter
*
09# to exit programming mode. Listen for 3 beeps and hang up.
❑
Redial the unit and append #1 immediately. When the Polling Controller connects
to the switch (you will hear a click and the LED changes modes), enter test#
(8378#) within 30 seconds to check the new password. Listen for 3 beeps.
to the switch (you will hear a click and the LED changes modes), enter test#
(8378#) within 30 seconds to check the new password. Listen for 3 beeps.
❑
Enter
*
09# to exit programming mode. Listen for 3 beeps and hang up.
Reference Manual
Chapter 4: Teltone Default LSS Operation with Polling Controller
40-400-00015, Rev.
F
Page 19