Teltone m-392 Guida Utente
Local Programming
If the telephone line is NOT connected to Jack A of the LSS:
q
Connect a DTMF telephone to LSS Port 2.
q
Go off-hook and dial ##
within 15 seconds. (No password is required.)
q
When you hear a confirmation tone (3 short beeps), begin programming.
A telephone line must be connected to the LSS:
q
Connect a DTMF telephone to Jack A of the LSS Port 1
q
Go off-hook and dial ##
within 15 seconds.
q
Enter the password within 30 seconds (default 8358663# or “Teltone”).
q
When you hear a confirmation tone (3 short beeps), begin programming.
Note:
The unit will exit the programming mode and disconnect if 60 seconds elapse
without entry of any DTMF digits.
If an invalid password is entered, there will be no acknowledgment. The user must
hang-up and wait for 30 seconds before attempting to re-enter the programming access
mode.
hang-up and wait for 30 seconds before attempting to re-enter the programming access
mode.
Example of a Local Programming Session
❑
Access Programming Mode (see previous section).
❑
Enter
*
21#0# to disable audible ringback on Port 2. When you hear 3 beeps, you
may enter another command or exit programming mode. If you hear error tone,
re-enter the command.
re-enter the command.
❑
Enter
*
50#1# to set emergency priority. Listen for 3 beeps.
❑
Enter
*
51#1#911#911# to enter the number 911 as the first emergency priority
number. Listen for 3 beeps.
❑
Enter
∗
51#2#4871515#4871515# to enter the number 487-1515 as the second
emergency priority number. Listen for three beeps.
❑
Enter
*
02#1# to enable Remote P. Listen for 3 beeps.
❑
Hang-up the phone to exit the programming mode.
Line Sharing Switch
Page 28