Teltone m-392 Guida Utente
Remote Programming
Remember: the LSS will exit the programming mode and disconnect if 60 seconds elapse
without entry of any DTMF digits.
without entry of any DTMF digits.
Example of a Remote Programming Session
❑
Dial the number of the LSS to be programmed and append #1 immediately after
hearing the first ring. The LSS will respond with a short modem answer burst
(default) and then three beeps.
hearing the first ring. The LSS will respond with a short modem answer burst
(default) and then three beeps.
❑
Enter the password within 30 seconds. The default password is: 8358663# If the
LSS accepts this entry as a valid password, it will issue three beeps. You can
begin programming.
LSS accepts this entry as a valid password, it will issue three beeps. You can
begin programming.
Note:
Always terminate a password entry with #.
If an invalid password is entered, there will be no acknowledgment of any kind. The user
must hang up and wait for 30 seconds before attempting to re-enter the programming
access mode.
must hang up and wait for 30 seconds before attempting to re-enter the programming
access mode.
Caution: If three consecutive and invalid programming access attempts are made, the
LSS will lock out all further access for 1 hour. You cannot disable the Remote
Programming feature while in remote programming mode.
LSS will lock out all further access for 1 hour. You cannot disable the Remote
Programming feature while in remote programming mode.
Example of a
Programming Command Sequence
❑
Enter
*
50#1# to set emergency priority. When you hear 3 beeps, you may enter
another command or exit programming mode. If you hear error tone, re-enter the
command.
command.
❑
Enter
*
51#1#911#911# to enter the number 911 as the first emergency priority
number. Listen for three beeps.
❑
Enter
*
51#2#18004263926#18004263926# to enter the number 1(800) 426-3926
as the second emergency priority number. Listen for three beeps.
❑
Enter
*
03#8378#8378# to change the password to “test” (8378). Listen for 3
beeps.
❑
Enter
*
06#4# to change the fax routing to Port 4. Listen for 3 beeps.
❑
Enter
*
09# to exit programming mode. Listen for 3 beeps and hang up.
❑
Redial the unit and append #1 immediately after hearing the first ring. When the
Polling Controller connects to the switch (you will hear a click and the LED
changes modes), enter test# (8378#) within 30 seconds to check the new
password. Listen for 3 beeps.
changes modes), enter test# (8378#) within 30 seconds to check the new
password. Listen for 3 beeps.
❑
Enter
*
09# to exit programming mode. Listen for 3 beeps and hang up.
Hang up when Transfer Code Absent
To Hang up the LSS if no transfer code is entered, send ## before the timeout period has
elapsed. This function may be useful for telephone callers wanting to avoid extended
ringing at the LSS.
elapsed. This function may be useful for telephone callers wanting to avoid extended
ringing at the LSS.
Reference Manual
Chapter 5: Standalone LSS Operation and Programming
40-400-00015, Rev.
F
Page 29