Epson CX11N Descrizione Prodotto

Epson AcuLaser CX11N/CX11NF

8/05

Epson AcuLaser CX11N/CX11NF

 - 

13

Always follow these precautions when replacing the 
photoconductor:
❏ The photoconductor weighs 6.16 lb (2.8 kg). Be sure to 

hold it firmly by the handle when carrying it.

❏ Avoid exposing the photoconductor to light any longer than 

necessary. 

❏ Be careful not to scratch the surface of the drum and belt. 

Also, avoid touching the drum; oil from your skin may 
permanently damage its surface and affect print quality.

❏ Do not store the photoconductor in an area subject to direct 

sunlight, dust, salty air, or corrosive gases (such as 
ammonia). Avoid locations subject to extreme or rapid 
changes in temperature or humidity. 

❏ Do not tilt the photoconductor.

Warning: 
Keep the photoconductor out of the reach of children.

Do not dispose of a used photoconductor in fire, as it may explode 
and cause injury. Dispose of it according to local regulations.

1. Make sure the CX11N is turned on.

2. Remove any paper loaded in the ADF (CX11NF only).

3. Slowly flip back the scanner until it stops.

4. Close the output tray extension.

5. Lift up cover B.

6. Pull up the orange lever inside cover B.

7. Lift out the photoconductor using its handle.

8. Remove the new photoconductor from its package and pull 

off the protective sheet.