Manualsbrain.com
  1. Manuali
  2. Marche
  3. Canon
  4. imagePROGRAF iPF9400S
  5. Manuale

Canon imagePROGRAF iPF9400S Manuale

Scarica
Pagina di 154
Cause
Corrective Action
The type of paper specified in the printer
driver does not match the type loaded in
the printer.
Make sure the same type of paper is specified in the printer driver as you have loaded in the
printer.
1.
Press the Stop button and stop printing.
2.
Change the type of paper in the printer driver and try printing again.
Scan Wait Time > Area in the Control
Panel menu is set to Leading edge.
When Scan Wait Time > Area is set to Leading edge, colors may be uneven 110–160 mm
from the leading edge. (The position varies depending on the Print Quality setting.)
In this case, select Scan Wait Time > Area > Entire area.
However, note that printing will now take longer.
 (See "Menu Settings.")
→User's Guide
Image edges are blurred or white banding occurs
Image edges are blurred or white banding occurs
Cause
Corrective Action
The Platen suction is too strong.
In the Control Panel menu, reduce the level of VacuumStrngth.
 (See "Adjusting the Vacuum Strength (VacuumStrngth).")
→User's Guide
Close the blue Switch on the platen so that it matches the paper size.
Incorrect Printhead alignment value.
When printing fine lines or text at high precision on glossy or semi-glossy photo or proofing paper,
set the optimal Printhead height before aligning the printhead.
 (See "Printing Fine Lines/Text or Photos at Higher Precision.")
→User's Guide
In the Control Panel menu, set Head Height to a lower height.
 (See "Adjusting the Printhead Height.")
→User's Guide
The type of paper specified in the
printer driver does not match the
type loaded in the printer.
Load paper of the same type as you have specified in the printer driver.
Make sure the same type of paper is specified in the printer driver as you have loaded in the print-
er.
1.
Press the Stop button and stop printing.
2.
Change the type of paper in the printer driver and try printing again.
Setting the Blue Switch on the Platen
Setting the Blue Switch on the Platen
If printed documents exhibit the following symptoms, adjust the setting of the blue Switch on the Platen.
•
Image edges are blurred
•
Image edges are affected by white banding
Important
•
Always set the blue Switch on the Platen to the ● side for borderless printing. Printing quality may be affected if the
Switch is incorrectly set.
1
Remove any loaded paper that will not be used.
•
Rolls 
•
iPF9400S
                                                                                                                                                  
Image edges are blurred or white banding occurs
                                                                                                                                                                                                                                 
   
Troubleshooting
Problems with the printing quality
115