Netgear FVS318N – Prosafe Wireless N VPN Firewall Guida All'Installazione Rapida
Initial Access and Basic IPv4 Internet Configuration
7
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
The Connection Status screen should show a valid IP address and gateway, and you are
connected to the Internet. If the configuration was not successful, go to the following
section.
connected to the Internet. If the configuration was not successful, go to the following
section.
Manually Configure an IPv4 Internet Connection
Unless your ISP dynamically assigns your IP address configuration through a DHCP server,
you need to use the ISP information that you collected in
you need to use the ISP information that you collected in
on page 4 to manually
establish an Internet connection:
•
•
•
•
ISP Connection with a Dynamic IP Address
To manually configure a dynamic IPv4 address for your ISP connection:
1.
Select Network Configuration > WAN Settings > Broadband ISP Settings.
In the upper right of the screen, the IPv4 radio button is selected by default. The ISP
Broadband Settings screen displays the IPv4 settings. (
Broadband Settings screen displays the IPv4 settings. (
on page 5 displays the
entire screen; this section shows separate sections of the screen.)
2.
Locate the Internet (IP) Address section of the screen:
Figure 4.
a. As an option, you can click the Current IP Address link to see the currently assigned
IP address.
b. Select the Get Dynamically from ISP radio button. The ISP automatically assigns
an IP address to the wireless VPN firewall using the DHCP network protocol.