Xerox Xerox Versant 80 Press with Xerox Versant 80 EX 80 Print Server Guida Utente
An output sample is printed.
12. Select Close.
13. Check the output sample printout, and measure the offset amount.
14. Select Long at Left or Long at Right.
15. Enter the measurement value you obtained previously in Values A Before Adjustment
13. Check the output sample printout, and measure the offset amount.
14. Select Long at Left or Long at Right.
15. Enter the measurement value you obtained previously in Values A Before Adjustment
field by touching the up/down arrow buttons.
16. Select Adjust.
17. Select Sample Printout again to print an output sample printout, and check the
17. Select Sample Printout again to print an output sample printout, and check the
adjustment results.
18. Make adjustments again if necessary.
19. Select Save.
20. Select Close until the Adjust Fold Position screen appears.
21. Select the tray in which you loaded paper in step 1, and then press the Start button.
22. Select the adjusted fold position type, and select Save.
23. Continue to select Save or Close until you are returned to the main Tools tab display.
24. Exit the administrator mode.
19. Select Save.
20. Select Close until the Adjust Fold Position screen appears.
21. Select the tray in which you loaded paper in step 1, and then press the Start button.
22. Select the adjusted fold position type, and select Save.
23. Continue to select Save or Close until you are returned to the main Tools tab display.
24. Exit the administrator mode.
Adjusting the Booklet Fold Position
1. Load paper in the desired tray.
2. Log in as the administrator.
3. Press the Machine Status button on the UI.
4. Select the Tools tab.
5. Select System Settings > Common Service Settings.
6. Select Maintenance > Finisher Adjustment
7. Select Adjust Fold Position.
8. Select Fold Position Type Setup, and select Change Settings.
9. Select Booklet and select Change Settings.
2. Log in as the administrator.
3. Press the Machine Status button on the UI.
4. Select the Tools tab.
5. Select System Settings > Common Service Settings.
6. Select Maintenance > Finisher Adjustment
7. Select Adjust Fold Position.
8. Select Fold Position Type Setup, and select Change Settings.
9. Select Booklet and select Change Settings.
10. Press Sample Printout.
11. Select the tray in which you loaded paper, select 2-Sheet Stack, and press the Start
11. Select the tray in which you loaded paper, select 2-Sheet Stack, and press the Start
button.
An output sample is printed.
An output sample is printed.
12. Select the tray in which you loaded paper, select 15-Sheet Stack, and press the Start
button.
An output sample is printed.
An output sample is printed.
13. Select Close.
14. Check the output sample, and measure the position offset amount for 2-sheet stack
14. Check the output sample, and measure the position offset amount for 2-sheet stack
and 15-sheet stack.
15. Press Booklet Fold State (2 Sheets).
16. Select the state of the fold and staple position of the output paper, and enter the
16. Select the state of the fold and staple position of the output paper, and enter the
2-sheet stack offset amount you measured in previously in Values A & B Before
Adjustment field.
Adjustment field.
17. Select Save.
18. Set Booklet Fold State (15 Sheets) in the same way.
18. Set Booklet Fold State (15 Sheets) in the same way.
Xerox
®
Versant
®
80 Press
3-24
System Administration Guide
System Settings (Tools Administrator Mode)