Xerox Xerox Versant 80 Press with Xerox Versant 80 EX 80 Print Server Guida Utente
20. Select the adjusted fold position type, and select Save.
21. Continue to select Save or Close until you are returned to the main Tools tab display.
22. Exit the administrator mode.
21. Continue to select Save or Close until you are returned to the main Tools tab display.
22. Exit the administrator mode.
Adjusting the Z Fold Position
1. Load paper in the desired tray.
2. Log in as the administrator.
3. Press the Machine Status button on the UI.
4. Select the Tools tab.
5. Select System Settings > Common Service Settings.
6. Select Maintenance > Finisher Adjustment
7. Select Adjust Fold Position.
8. Select Fold Position Type Setup, and select Change Settings.
9. Select Z Fold-A4 or Z Fold-8.5x11”, and select Change Settings.
2. Log in as the administrator.
3. Press the Machine Status button on the UI.
4. Select the Tools tab.
5. Select System Settings > Common Service Settings.
6. Select Maintenance > Finisher Adjustment
7. Select Adjust Fold Position.
8. Select Fold Position Type Setup, and select Change Settings.
9. Select Z Fold-A4 or Z Fold-8.5x11”, and select Change Settings.
10. Select Sample Printout.
11. Select the tray in which you loaded paper, and press the Start button.
11. Select the tray in which you loaded paper, and press the Start button.
An output sample is printed.
12. Select Save.
13. Check the output sample, and measure the A and B fold position movement amounts.
14. Enter the measurement value you obtained in the previous step in Values A & B Before
13. Check the output sample, and measure the A and B fold position movement amounts.
14. Enter the measurement value you obtained in the previous step in Values A & B Before
Adjustment, and the final value you want after adjustment in Desired Values A & B.
Tip
Set value A and value B so that an edge of the paper does not extend past a fold
position of the paper. An edge of paper extending past a fold position of the paper
may cause a paper jam.
position of the paper. An edge of paper extending past a fold position of the paper
may cause a paper jam.
15. Select Sample Printout again to print an output sample, and check the adjustment
results.
16. Make adjustments again if necessary.
17. Select Save.
18. Select Close until the Adjust Fold Position screen appears.
19. Select the tray in which you loaded paper in step 1, and then press the Start button.
20. Select the adjusted fold position type, and select Save.
21. Continue to select Save or Close until you are returned to the main Tools tab display.
22. Exit the administrator mode.
17. Select Save.
18. Select Close until the Adjust Fold Position screen appears.
19. Select the tray in which you loaded paper in step 1, and then press the Start button.
20. Select the adjusted fold position type, and select Save.
21. Continue to select Save or Close until you are returned to the main Tools tab display.
22. Exit the administrator mode.
Adjusting the Z Fold Half Sheet Position
1. Load paper in the desired tray.
2. Log in as the administrator.
3. Press the Machine Status button on the UI.
4. Select the Tools tab.
5. Select System Settings > Common Service Settings.
6. Select Maintenance > Finisher Adjustment
2. Log in as the administrator.
3. Press the Machine Status button on the UI.
4. Select the Tools tab.
5. Select System Settings > Common Service Settings.
6. Select Maintenance > Finisher Adjustment
Xerox
®
Versant
®
80 Press
3-26
System Administration Guide
System Settings (Tools Administrator Mode)