Xerox Xerox Versant 80 Press with Xerox Versant 80 EX 80 Print Server Guida Utente
7. Select Adjust Fold Position.
8. Select Fold Position Type Setup, and select Change Settings.
9. Select Z Fold Half Sheet- A3, Z Fold Half Sheet- B4, Z Fold Half Sheet-11x17”, or
8. Select Fold Position Type Setup, and select Change Settings.
9. Select Z Fold Half Sheet- A3, Z Fold Half Sheet- B4, Z Fold Half Sheet-11x17”, or
Z Fold Half Sheet - 8K, and select Change Settings.
10. Select Sample Printout.
11. Select the tray in which you loaded paper, and press the Start button.
11. Select the tray in which you loaded paper, and press the Start button.
An output sample is printed.
12. Select Save.
13. Check the output sample, and measure the A and B fold position movement amounts.
14. Enter the measurement value you obtained in the previous step in Values A & B Before
13. Check the output sample, and measure the A and B fold position movement amounts.
14. Enter the measurement value you obtained in the previous step in Values A & B Before
Adjustment, and the final value you want after adjustment in Desired Values A & B.
Tip
Set value B so that an edge of the paper does not extend past a fold position of the
paper. An edge of paper extending past a fold position of the paper may cause a
paper jam.
paper. An edge of paper extending past a fold position of the paper may cause a
paper jam.
15. Select Sample Printout again to print an output sample, and check the adjustment
results.
16. Make adjustments again if necessary.
17. Select Save.
18. Select Close until the Adjust Fold Position screen appears.
19. Select the tray in which you loaded paper in step 1, and then press the Start button.
20. Select the adjusted fold position type, and select Save.
21. Continue to select Save or Close until you are returned to the main Tools tab display.
22. Exit the administrator mode.
17. Select Save.
18. Select Close until the Adjust Fold Position screen appears.
19. Select the tray in which you loaded paper in step 1, and then press the Start button.
20. Select the adjusted fold position type, and select Save.
21. Continue to select Save or Close until you are returned to the main Tools tab display.
22. Exit the administrator mode.
Using DFA Finisher Profiles (for Third-Party Finishing Devices)
Use the DFA Finisher Profiles feature to create a profile for the specified DFA device and
add, edit or delete attributes for the device, such as timing values.
add, edit or delete attributes for the device, such as timing values.
Note
For information about the DFA settings to enter for the device, refer to the third-party
DFA Finisher documentation.
DFA Finisher documentation.
1. Log in as the administrator.
2. Press the Machine Status button on the UI.
3. Select the Tools tab.
4. Select System Settings > Common Service Settings.
5. Select Maintenance.
6. Scroll down the list to locate and select Finisher Adjustment and DFA Finisher
2. Press the Machine Status button on the UI.
3. Select the Tools tab.
4. Select System Settings > Common Service Settings.
5. Select Maintenance.
6. Scroll down the list to locate and select Finisher Adjustment and DFA Finisher
Profiles.
7. From the DFA Finisher Profiles screen:
a) If adding a new third-party finisher, select an available row and select Create/Edit.
Enter the name and other attributes for that device.
3-27
Xerox
®
Versant
®
80 Press
System Administration Guide
System Settings (Tools Administrator Mode)