Xerox Xerox Versant 80 Press with Xerox Versant 80 EX 80 Print Server Guida Utente
Suggested solutions
Problem
The press does not power
on.
on.
• Ensure the power cord from the press is plugged into the power
outlet/receptacle correctly. If not, press the main power switch
inside the front door to off and then firmly plug in the power
cord. Then press the power switch on.
inside the front door to off and then firmly plug in the power
cord. Then press the power switch on.
• Ensure the power switch inside the front door is set to the ON
position. Press firmly on the On/Off button located on top of
the press near the UI.
the press near the UI.
• Make sure that the power supply is 200 -240 V (volts), 30A
(amperes).
Make sure that power of capacity compatible with the specified
maximum power consumption of the press (2.8 - 3.1 KVA) is
being supplied.
Make sure that power of capacity compatible with the specified
maximum power consumption of the press (2.8 - 3.1 KVA) is
being supplied.
• Check the Ground Fault Interrupter (GFI) circuit breakers.
• If the power in your location is working properly, and you have
tried the suggested solutions but the press does not power on,
contact the Customer Support Center for assistance.
contact the Customer Support Center for assistance.
The press UI is locked up or
completely dark.
completely dark.
• If the UI buttons or keyboard do not work, press the power
button on the press to power down the print engine. Wait 30
seconds and press the power button again to reboot the system.
seconds and press the power button again to reboot the system.
• If the Power Saver button is on (lit), the press is in the Power
Saver mode. Press the Power Saver button on the UI to cancel
the Power Saver mode.
the Power Saver mode.
Open Paper Tray 1. The serial number is located on the left frame
near Tray 1.
near Tray 1.
There is no power to the
press, and you cannot ac-
cess the Machine Status
screen to get the press seri-
al number.
press, and you cannot ac-
cess the Machine Status
screen to get the press seri-
al number.
The press does not success-
fully complete a print job.
fully complete a print job.
• Is your press connected to the network? Try printing a test page
from the print server to the press to verify that the press is
connected on the network.
connected on the network.
• Verify that the power cable is connected to the press and to a
suitable power outlet.
• Verify that the network cables are attached securely to the
press and seated properly.
• Clear out the print job from the print queue and resend print
job.
• Power Off/On the press to restart it.
• Your press may not be configured on the network. Contact your
System Administrator to connect the press to the network.
14-3
Xerox
®
Versant
®
80 Press
User Guide
Press Problem Solving