Xerox Xerox Versant 80 Press with Xerox Versant 80 EX 80 Print Server Guida Utente
Die Stop Position
On some of the AdvancedPunch Pro die sets there is an adjustable die stop which is used
to change the hole position for the die set for certain sheet sizes, as shown in the following
illustration.
to change the hole position for the die set for certain sheet sizes, as shown in the following
illustration.
Note
For die sets without a die stop knob there is no die stop position adjustment necessary.
1.
Die Stop Handle Label:
Common paper sizes are shown on the die stop handle label below the die stop
knob.
knob.
2.
Die Stop Knob:
For units with a die stop knob, the die stop must be set to the correct position or the
punched holes will not be centered on the sheet.
punched holes will not be centered on the sheet.
3.
Position A:
This is when the arrow on the die stop knob points down towards the handle and
lines up with the lower arrow on the die stop handle label.
lines up with the lower arrow on the die stop handle label.
4.
Position B:
This is when the arrow on the die stop knob points to the side and lines up with the
side arrow on the die stop handle label.
side arrow on the die stop handle label.
Refer to these tables:
and
.
Die Stop Position Guide for US Paper Sizes
Wire 3:1
Square
Square
Wire 2:1
Square
Square
CombBind
Wire 3:1
Round
Round
Wire 2:1
Round
Round
Coil Round
US Paper
Size
Size
Die Stop Position Based On Paper Size or Orientation
A
A
A
A
A
B
LTR LEF
B
A
A
B
A
B
LTR SEF
Xerox
®
Versant
®
80 Press
22-10
User Guide
GBC AdvancedPunch Pro