Xerox Xerox Versant 80 Press with Xerox Versant 80 EX 80 Print Server Guida Utente
Note
Refer to the print server documentation for more detailed information on how to set up
a tab job at your print server.
a tab job at your print server.
Note
If a jam occurs while running tabbed sets, cancel the job and start again.
1. After programming your tab job at the print server, select the appropriate and
matching tab stock for your print job.
2. Pull out the tray slowly until it stops.
3. Fan the tab paper before loading into the tray.
4. Load the tab stock LEF (portrait) and align the straight edge of the tab stock against
3. Fan the tab paper before loading into the tray.
4. Load the tab stock LEF (portrait) and align the straight edge of the tab stock against
the right edge of the tray (tabs to the left or trailing edge). For single straight collated
tabs, the first blank tab cutout in the stack will be toward the front of the tray. For
single reverse collated tabs, the first blank tab cutout in the stack will be toward the
rear of the tray.
tabs, the first blank tab cutout in the stack will be toward the front of the tray. For
single reverse collated tabs, the first blank tab cutout in the stack will be toward the
rear of the tray.
Tab stock is loaded so the straight edge of the stock is in the feed direction. Also, you
can only load the tab stock LEF.
can only load the tab stock LEF.
5. Adjust the paper guides by pressing in the guide release and carefully moving the
Edge Guide until it lightly touches the edge of the stock in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
6. Gently push in the tray until it comes to a stop.
The Paper Tray Properties window displays from the Stock Library Manager on the
print server. The Stock Library Manager is available from the print server only and
not at the press.
print server. The Stock Library Manager is available from the print server only and
not at the press.
7. From the Tray Properties window, confirm the correct tray to which it is printing and
other information, including size (9 x 11 inches), type (precut tab), and, if necessary,
paper curl and / or alignment option.
paper curl and / or alignment option.
8. Select OK to save the information and close the Tray Properties window.
Loading Transparencies in the OHCF (Trays 8 and 9)
Note
Do not use transparencies with a white side strip (either permanent or removable).
At the Stock Library Manager, make sure to select Transparency as the Paper or Media
Type and select the tray containing the transparencies as the Paper Source.
1. Select the appropriate paper stock for your print job.
2. Pull out the tray slowly until it stops.
3. Fan the transparencies to stop them from sticking together before loading into the
Type and select the tray containing the transparencies as the Paper Source.
1. Select the appropriate paper stock for your print job.
2. Pull out the tray slowly until it stops.
3. Fan the transparencies to stop them from sticking together before loading into the
tray.
3-19
Xerox
®
Versant
®
80 Press
User Guide
Paper and Media