Philips HR 1627/00 Manuale Utente

Pagina di 14
ENGLISH
Introduction
Congratulations on your purchase and welcome to Philips! To fully benefit from the 
support that Philips offers, register your product at www.philips.com/welcome.
General description
1  Turbo button
2  Power-on button
3  Motor unit
4  Release button
5  Bar blender
6  Whisk coupling unit (HR1627/HR1625 only)
7  Whisk (HR1627/HR1625 only)
8  XL chopper lid (HR1627 only)
9  Mini chopper lid (HR1625, HR1623 only)
10  XL chopper blade unit (HR1627 only)
11  Mini chopper blade unit (HR1625, HR1623 only)
12  XL chopper bowl (HR1627 only)
13  Mini chopper bowl (HR1625/HR1623 only)
14 Beaker
15  User manual
16  Worldwide guarantee leaflet
Important
Read this user manual carefully before you use the 
appliance and save it for future reference.
Danger
 - Never immerse the motor unit in water or any other 
liquid, nor rinse it under the tap. Only use a moist 
cloth to clean the motor unit.
Warning
 - Check if the voltage indicated on the appliance 
corresponds to the local mains voltage before you 
connect the appliance.
 - Do not use the appliance if the plug, the mains cord 
or other parts are damaged.
 - If the mains cord is damaged, you must have it replaced 
by Philips, a service centre authorised by Philips or 
similarly qualified persons in order to avoid a hazard.
 - This appliance is not intended for use by persons 
(including children) with reduced physical, sensory 
or mental capabilities, or lack of experience and 
knowledge, unless they have been given supervision 
or instruction concerning use of the appliance by a 
person responsible for their safety.
 - Children should be supervised to ensure that they do 
not play with the appliance.
 - Do not allow children to use the appliance without 
supervision.
 - Do not touch the cutting edges of the blade units, 
especially when the appliance is plugged in. The 
cutting edges are very sharp.
 - Never use the chopper blade unit without a chopper bowl.
 - Never let the appliance operate unattended.
 - Be careful to avoid splashing when you process hot 
ingredients.
 - None of the accessories are suitable for use in the 
microwave.
 - If one of the blade unit gets stuck, unplug the 
appliance before you remove the ingredients 
that block the blade units.
 - If a part or an accessory is damaged, always have it 
replaced with one of the original type, otherwise your 
guarantee is no longer valid.
Caution
 - Switch off the appliance and disconnect it from the mains 
before you assemble, disassemble, store and clean it.
 - Never use any accessories or parts from other 
manufacturers or that Philips does not specifically 
recommend. If you use such accessories or parts, your 
guarantee becomes invalid.
 - This appliance is intended for household use only. If 
the appliance is used improperly or for professional 
or semi-professional purposes or if it is not used 
according to the instructions in the user manual, the 
guarantee becomes invalid and Philips refuses any 
liability for damage caused.
 - Keep the motor unit away from heat, fire, moisture 
and dirt.
 - Never fill the beaker or bowl with ingredients that are 
hotter than 80°C/175°F.
 - Do not exceed the quantities and processing times 
indicated in the tables.
 - Do not process more than one batch without 
interruption. Let the appliance cool down for 10 
minutes before you continue processing.
 - Maximum noise level: 85 db(A)
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and regulations regarding 
exposure to electromagnetic fields.
Cleaning and maintenance
Never immerse the motor unit, the whisk coupling unit (HR1627/HR1625), the XL 
chopper lid (HR1627), and the mini chopper lid (HR1625/HR1623) in water or any 
other liquid, nor rinse them under the tap. Use a moist cloth to clean these parts.
Before you start cleaning:
 1 
 Unplug the appliance.
 2 
 Press the release button to remove the accessory attached. 
 3 
 Disassemble the accessory.
Tip: You can remove the rubber rings from the chopper bowls for extra thorough cleaning.
Tip: For quick cleaning of the blender bar, empty and rinse the beaker immediately after 
use. Then pour warm water with some washing-up liquid in the beaker, insert the blender 
bar and let the appliance operate for approx. 10 seconds.
Accessories
You can order a direct-driven mini chopper (under service code number 4203 035 
83450) from your Philips dealer or a Philips service centre as an extra accessory for 
the HR1621 and HR1627.
Environment
 - Do not throw away the appliance with the normal household waste at the end 
of its life, but hand it in at an official collection point for recycling. By doing this, 
you help to preserve the environment (Fig. 1).
Guarantee and support
If you need information or support, please visit www.philips.com/support or read 
the separate worldwide guarantee leaflet. 
Frequently asked questions
Question
Answer
Why does the appliance 
make a lot of noise, 
produce an unpleasant 
smell, produce smoke or 
feel hot?
You may have used the appliance too long without 
interruption. If this is the case, stop using the appliance 
and let it cool down for 60 minutes. If the problem 
persists, contact your Philips dealer or a service centre 
authorised by Philips.
Can I process boiling hot 
ingredients?
Let the ingredients cool down to approx. 80°C/175°F 
before you process them.
Which size should the 
ingredients have before I 
process them?
Cut the ingredients into pieces of approx. 2x2cm.
Can I process very hard 
ingredients?
No, the appliance may get damaged if you process very 
hard ingredients such as bones and fruit with stones. 
However, the appliance is suitable for processing 
ingredients like Parmesan cheese or chocolate.
Why does the appliance 
suddenly stop working?
Some hard ingredients may block the blade unit. 
Release the on/off or turbo button and unplug the 
appliance. Then detach the motor unit and remove the 
ingredients that block the blade unit.