Cisco Cisco Unified MeetingPlace 5.3 Manuale Di Manutenzione

    Temperature: 

22C

    Voltages: 

3.34V, 5.02V, 12.00V

Power Supplies:

OK

Fans:

OK

SCSI Adapter:

NCR 810

    DISK 1:

36000MB (SEAGATE ST336607LC       REV=0005)

    DISK 2:

36000MB (SEAGATE ST336607LC       REV=0005)

Ethernet:

Intel 8225x PCI 10/100 (0001af0bc2cd)

Modem:

Absent or unrecognized

Multi Access Blades:

    Slot 1:

AC TP1610-4 S/N=274404  REV=0 AC0

Smart Blades:

Slot 2:

NMS CG6000C S/N=103237639 REV=5894-B4 MSC0 PRC0

Verify that the fans are active by listening for at least some minimal fan noise.

Verify that the fans in the fan tray are moving air by doing both of the following:

Place a small piece of paper on the left side of the Cisco MeetingPlace system (as you face the front 
of it). Ensure that the paper moves toward the fan vent.

Place a small piece of paper on the right side of the Cisco MeetingPlace system (as you face the front 
of it). Ensure that the paper moves away from the fan vent.

Verify that the fans are not too loud and do not make any noises that might indicate bad bearings. If you 
hear anything louder than a hum, this might indicate that one or more of the fans in the fan tray are bad. 
If you experience this, contact Cisco TAC.

Ensure that all the gateways work. See the Administrator Guides for the specific gateways for 
information on determining that they are working correctly.

Ensure that you can call into the Cisco MeetingPlace system and attend a meeting. If you cannot call 
into the Cisco MeetingPlace system and attend a meeting, try reseating the fan tray. If that does not work, 
contact Cisco TAC.