Cisco Cisco Unified MeetingPlace 5.3 Manuale Di Manutenzione

Fan Tray Replacement Procedure for the Cisco MeetingPlace 8106

OL-6458-01

How To Replace the Fan Tray

Installing the New Fan Tray

Step 1

Remove the new fan tray from the antistatic bag.

Step 2

Slide the fan tray into the empty slot on the front left of the Cisco MeetingPlace 8106 chassis. See

. Apply firm pressure when you slide the fan tray into the chassis to ensure that the power

connectors fit properly. These power connectors have a flexible design to ensure that they are not
misaligned during the fan tray installation.

Figure 2

Inserting the Fan Tray into the Cisco MeetingPlace 8106

Step 3

Manually tighten the screws that secure the fan tray to the Cisco MeetingPlace 8106 chassis. No
screwdriver is needed.

Powering Up the Cisco MeetingPlace 8106

Step 1

Plug the power cable into the back of the Cisco MeetingPlace 8106.

Step 2

Locate the power switch on the back of the Cisco MeetingPlace 8106 and turn it to the on position (“ | ”).

Step 3

Start the terminal emulator program on your computer. See the

for information about how to start the terminal emulator program.

Step 4

Access the CLI.

Step 5

Step 6

To ensure that the new fan is working properly, enter hwconfig. Output similar to the following example
appears:

meetingplace:tech$ hwconfig

Cabinet: ELMA

Bus architecture:

CompactPCI

Processor card:

SMM5370LATUDE S/N=6055691

Processor:

Pentium III, Model 8, 700 MHz

Memory:

512 MB

121615