Cisco Cisco WAP150 Wireless-AC N Dual Radio Access Point with PoE Manuale Di Manutenzione

Using the Access Point Setup Wizard

Cisco WAP150 and WAP361 Administration Guide

11

In the address bar, enter the default DHCP address and press the Enter key.

Enter the default user name of cisco and password of cisco in the Username and 
Password fields.

Click Log In. The Access Point Setup Wizard appears.

Follow the Setup Wizard instructions to finish the WAP device installation. We 
strongly recommend that you use the Setup Wizard for the first installation. See 

 for more information. 

By default, the configuration utility logs out after 10 minutes of inactivity. See 

 for instructions on changing the default timeout period.

To log out, click Logout in the top right corner of the configuration utility.

The first time that you log into the WAP device (or after it has been reset to the 
factory default settings), the Access Point Setup Wizard appears to help you 
perform initial configuration. 

If you click Cancel to bypass the wizard, the Change Password page appears. You 
can then change the default password for logging in (see 

 for more information). For all other settings, the factory default 

configurations apply. 

Follow these steps to complete the wizard (you must log in again after changing 
your password):

Click Next on the Welcome page of the wizard. The Configure Device - IP Address 
window appears.

Click Dynamic IP Address (DHCP) if you want the WAP device to receive an IP 
address from a DHCP server, or click Static IP Address to configure the IP 
address manually. For a description of these fields, see 

Click Next. The Single Point Setup — Set A Cluster window appears. For a 
description of Single Point Setup, see 

.