Cisco Cisco TelePresence MX700 Riferimenti tecnici
D15335.04
Cisco TelePresence MX700 and MX800 API Reference Guide CE8.2, JUNE 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
104
Cisco TelePresence MX700 and MX800
API Reference Guide
xConfiguration Video Selfview Default PIPPosition
Define the position on screen of the small self-view picture-in-picture (PiP) after a call. The
setting only takes effect when self-view is switched on (see the Video Selfview Default Mode
setting) and fullscreen view is switched off (see the Video Selfview Default FullscreenMode
setting).
Requires user role: ADMIN
Default value: Current
Default value: Current
USAGE:
xConfiguration Video Selfview Default PIPPosition:
PIPPosition
where
PIPPosition
: Current/UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/
LowerLeft/LowerRight
Current: The position of the self-view PiP will be kept unchanged when leaving a call.
UpperLeft: The self-view PiP will appear in the upper left corner of the screen.
UpperCenter: The self-view PiP will appear in the upper center position.
UpperRight: The self-view PiP will appear in the upper right corner of the screen.
CenterLeft: The self-view PiP will appear in the center left position.
CentreRight: The self-view PiP will appear in the center right position.
LowerLeft: The self-view PiP will appear in the lower left corner of the screen.
LowerRight: The self-view PiP will appear in the lower right corner of the screen.
UpperLeft: The self-view PiP will appear in the upper left corner of the screen.
UpperCenter: The self-view PiP will appear in the upper center position.
UpperRight: The self-view PiP will appear in the upper right corner of the screen.
CenterLeft: The self-view PiP will appear in the center left position.
CentreRight: The self-view PiP will appear in the center right position.
LowerLeft: The self-view PiP will appear in the lower left corner of the screen.
LowerRight: The self-view PiP will appear in the lower right corner of the screen.
xConfiguration Video Selfview OnCall Mode
This setting is used to switch on self-view for a short while when setting up a call. The Video
Selfview OnCall Duration setting determines for how long it remains on. This applies when self-
view in general is switched off.
Requires user role: ADMIN
Default value: On
Default value: On
USAGE:
xConfiguration Video Selfview OnCall Mode:
Mode
where
Mode
: Off/On
Off: self-view is not shown automatically during call setup.
On: self-view is shown automatically during call setup.
Off: self-view is not shown automatically during call setup.
On: self-view is shown automatically during call setup.
xConfiguration Video Selfview OnCall Duration
This setting only has an effect when the Video Selfview OnCall Mode setting is switched On. In
this case, the number of seconds set here determines for how long self-view is shown before it
is automatically switched off.
Requires user role: ADMIN
Default value: 10
Default value: 10
USAGE:
xConfiguration Video Selfview OnCall Duration:
Duration
where
Duration
: Integer (1..60)
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xConfiguration