Cisco Cisco Unified MeetingPlace SMTP E-Mail Gateway Manuale Di Manutenzione
4-4
Cisco MeetingPlace E-Mail Gateway System Manager’s Guide
OL-6001-01
Chapter 4 Managing MeetingPlace E-Mail Gateway
MeetingPlace Gateways Configuration Utility
Gateway SIM Tab
The Gateway System Integrity Manager (SIM) improves the reliability and serviceability of your
MeetingPlace E-Mail Gateway by:
MeetingPlace E-Mail Gateway by:
•
Detecting gateway outages and logging these errors to the MeetingPlace Alarm Table.
•
Enabling a MeetingPlace support representative to remotely administer and diagnose your
MeetingPlace E-Mail Gateway.
MeetingPlace E-Mail Gateway.
The Gateway SIM is installed along with the MeetingPlace E-Mail Gateway during the installation, and
both will run as NT Services.
both will run as NT Services.
The Gateway SIM periodically sends updates to the Gateway SIM Manager, which resides on
MeetingPlace. If the Gateway SIM Manager does not receive these updates when expected, it logs a
major alarm to the MeetingPlace Alarm Table.
MeetingPlace. If the Gateway SIM Manager does not receive these updates when expected, it logs a
major alarm to the MeetingPlace Alarm Table.
The Gateway SIM also enables a MeetingPlace support representative to issue remote commands that
can be used to diagnose or restart your MeetingPlace E-Mail Gateway.
can be used to diagnose or restart your MeetingPlace E-Mail Gateway.
provides information about the Gateway SIM tab.
Figure 4-4
Gateway SIM Tab
Each field in the Gateway SIM tab is explained below:
Primary MeetingPlace Server. Contains the hostname or IP address of the MeetingPlace Network
Server (or MeetingPlace Standalone Server). To modify this field, refer to the Change Unit
Configuration parameter.
Server (or MeetingPlace Standalone Server). To modify this field, refer to the Change Unit
Configuration parameter.
Shadow Server. Contains the hostname or IP address of the shadow server if the Domain Name System
(DNS) is not being used. If DNS is being used, this field should be left empty. This field becomes
editable only when adding a new unit configuration (refer to the Change Unit Configuration parameter).
(DNS) is not being used. If DNS is being used, this field should be left empty. This field becomes
editable only when adding a new unit configuration (refer to the Change Unit Configuration parameter).