Cisco Cisco Unified MeetingPlace Video Integration Guida All'Installazione
4
How To Verify Preparedness of Component Systems
•
•
•
Verifying That the MCU Can Run Video Conferences Independently of Cisco Unified MeetingPlace, page 4
Meeting the Requirements for This Configuration
Make sure your equipment, software and network characteristics meet the requirements for the configuration detailed in this
document. See
document. See
Verifying That Your Cisco Unified MeetingPlace System Works Without Video
Procedure
Step 1
Make sure audio participants can dial in to join a conference.
Step 2
Make sure the system can dial out to audio participants to bring them into the conference.
Step 3
Make sure all participants can successfully hear each other and participate in the same web conference.
Verifying That the MCU Can Run Video Conferences Independently of Cisco Unified MeetingPlace
Procedure
Step 1
Schedule a video conference on the MCU.
Step 2
Make sure video endpoints can dial in to join a video conference.
Step 3
Make sure the MCU can dial out to video endpoints to bring them into the conference.
Step 4
Make sure all video endpoints can see and hear each other in the video conference.
Configuring the MCU
Procedure
Step 1
Log in to your MCU Administrator interface.
Step 2
Synchronize the MCU with the NTP server:
a.
For Model 3515 MCU: Click Device.
For Model 3545 MCU: Click Board.
b.
Click the Basics tab.
c.
For Date/Time, click Change.
d.
Check NTP Enabled.
e.
Click Synchronize with NTP server address.
f.
Enter the IP address of the NTP server.
g.
Click Upload.
Step 3
Check to be sure the port addressing is correct:
a.
Click the Addressing tab.