Cisco Cisco D9824 Advanced Multi Decryption Receiver Guida All'Installazione
Setting the DPM Mode
78-4039426-01 Rev D
7
Setting the DPM Mode
A program can be set to one of three Digital Program Mapping (DPM) modes, either
Drop, Pass or Map respectively. For more information, see TS Out - DPM (on page
94) .
Drop, Pass or Map respectively. For more information, see TS Out - DPM (on page
94) .
LCD Setting
Description
Drop
Removes the service and its associated PMT reference
from the transport output.
from the transport output.
Pass
Permits the source content and PMT reference to appear
in the transport output with the same references unless
the source material is mapped on another PE.
in the transport output with the same references unless
the source material is mapped on another PE.
Map
Provides the flexibility to define all the outgoing PID
numbers for a PE, including those not currently on
transmission.
numbers for a PE, including those not currently on
transmission.
1 Press MENU to display the Main Menu.
2 Press
2 Press
to move to the Setup menu. Press SELECT.
3 Press
five times to move to the Outputs menu. Press SELECT.
4 Press
to move to the TS Out menu. Press SELECT.
5 Press
to move to the DPM menu. Press SELECT.
6 Press SELECT to access the Global menu.
7 Press SELECT to choose ASI for Resync All. Press and then press SELECT to
7 Press SELECT to choose ASI for Resync All. Press and then press SELECT to
continue.
8 Press MENU. Press
to move to the ASI menu. Press SELECT. Verify the PE1
”InCh” and ”OutCh” programs.
9 Press
three times to choose Act. Press SELECT. Use to select the DPM
action for the PID associated with the PE. Press SELECT. Press APPLY. Press
SELECT to save the changes.
SELECT to save the changes.
10 Press MENU six times to return to the start-up screen.