Adaptec ANA-62011/TX Single-Port, 20pck ANA-62011/TX 20PK Dépliant

Codici prodotto

ANA-62011/TX 20PK

Adaptec, Inc.
691 South Milpitas Boulevard
Milpitas, California 95035
Tel: (408) 945-8600
Fax: (408) 262-2533

Adaptec Europe - Belgium
Tel: (32) 2-352-34-11
Fax: (32) 2-352-34-00

Adaptec Japan - Tokyo
Tel: (81) 3-5365-6700
Fax: (81) 3-5365-6950

Adaptec Singapore
Tel: (65) 278-7300
Fax: (65) 273-0163

Literature:
1-800-934-2766 (USA and Canada)
or (510) 732-3829

Pre-Sales Support:
1-800-442-7274 (USA and Canada)
or (408) 957-7274

World Wide Web:
http://www.adaptec.com

Internet ftp server: ftp.adaptec.com
Adaptec USA Bulletin Board
Service (BBS): (408) 945-7727

(up to 28,800 baud, using 8 bits,
1 stop bit, no parity)

Interactive Fax: (303) 684-3400

Adaptec, the Adaptec logo, the Adaptec tagline, the

Bandwidth by Adaptec logo, AAA, AIC, ANA, Duo64,

DuraLAN, Duralink, Single32, Single64, and Quartet64

are trademarks of Adaptec, Inc., which may be regis-

tered in some jurisdictions. Windows, Windows NT,

Windows 95, and Windows 98 are registered trademarks

of Microsoft Corporation, used under license. All other

trademarks used are owned by their respective owners.

Information supplied by Adaptec, Inc. is believed to

be accurate and reliable at the time of printing, but

Adaptec, Inc. assumes no responsibility for any errors

that may appear in this document. Adaptec, Inc.

reserves the right, without notice, to make changes

in product design or specifications. Information is

subject to change without notice.

P/N 985482-011

6/98 Printed in U.S.A.

Single

Technical Specifications

Systems supported:

PCI Local Bus system

Configuration:

One Ethernet/Fast Ethernet port

Bus Interface:

PCI, native 64-bit bus master PCI 2.1, 3.3 volt and 5.5 volt supported
Compatible with 32-bit PCI 2.1

Bus Addressing:

64-bit addressing of DMA descriptor queues and buffers

Ethernet Controller:

Adaptec AIC™-6915 LAN controller chip

FIFO Buffer Memory:

8 KBytes for transmit and receive

Hardware Interrupts:

PCI interrupt A
Supports shared interrupts

Base IO or Memory Address:

Assigned by BIOS

PCI Configuration Space:

Supports DWORD, WORD, and BYTE access

Reliability:

Calculated MTBF>100,000 hours

Power Requirements:

+5 volts @ less than 2 AMPS

Environmental Operating Range: Temperature: 0 to 55 degrees Celcius
Relative Humidity:

5% to 85% non-condensing

Altitude:

3000m maximum

Interface Connections:

RJ-45 female connector
Support for CAT 3, 4, and 5 UTP and Type 1 STP for 10BaseT
operation, and CAT 5 UTP and Type 1 STP for 100BaseT operation.
Full-duplex support

Dimensions:

Conforms to PCI Short Form Factor for 64-bit bus

Standards Compliance:

IEEE 802.3 10BaseT
IEEE 802.3u 100BaseTX
Fully compliant autonegotiation
FCC Class B
CE Class B

Drivers Available:

Novell NetWare 4.1x
Client32 for DOS
Windows NT 3.51 and 4.0
Windows 95
Windows 98

Duralink Software:

Duralink Failover and Server Manager software at no charge

Diagnostic LEDs:

Link Integrity and Network Activity

Warranty:

Adaptec’s Ethernet NICs are protected by a limited lifetime warranty