Cisco Cisco UCS C210 M1 General-Purpose Rack-Mount Server Scheda Tecnica

The base server motherboard comes with an integrated SATA RAID 0/1 controller, which supports 
SATA drives only (SAS drives are not supported). Therefore, a controller is not required when 
ordering SATA drives and a RAID 0 or 1 configuration is desired.

You can use the built-in SATA RAID 0/1 controller or you can also choose to implement other RAID 
configurations by using optional plug-in PCIe cards or an optional mezzanine board on the server 
motherboard.

Cisco can provide factory-configured RAID 0, 1, 1E, 5, 6, and 10 systems depending on the RAID 
card chosen and the number of drives ordered. Factory-configured RAID options are listed with 
each RAID card description. Note that RAID levels 50 and 60 are supported on the 9280-4i4e and 
9260-4i, but are not factory configurable

Choose one RAID controller, one RAID configuration option, and, if desired, a battery backup 
option listed in 

UCSC-RAID-C-4I4E

LSI MegaRAID SAS 9280-4i4e, four internal and four external ports

■

Takes up one of two available PCIe slots

■

Supports up to four internal SAS or SATA drives

■

Supports external JBOD expansion

■

No battery backup option available

■

Factory-configured RAID options: RAID 0, 1, 5, 6, 10 (see the RAID PIDs 

section in this table)

R200-PL004

LSI MegaRAID SAS/SATA 9260-4i (RAID 0, 1, 5, 6, 10)

■

Takes up one of two available PCIe slots

■

Supports up to four SAS and/or SATA drives

■

Includes 512 MB of write cache

■

Battery backup option available (see the battery backup PID section in this 

table)

■

Factory-configured RAID options: RAID 0, 1, 5, 6, 10 (see the RAID PIDs 

section in this table)