Cisco Cisco UCS B200 M4 Blade Server Scheda Tecnica
Figure 5. DIMM Slot Numbering
Each channel pair is identified by a letter: A, B, C, or D for each CPU. Each DIMM pair member is identified by
numbers, 0, 1, 2 or 3. Additional DIMMs must be installed as shown in Table 2.
1
The slots inside the brackets are electrically paired with each other, and should be populated with identical matched
DIMMs that were ordered as a pair. Do not swap a paired DIMM with a DIMM that is not identical in manufacturer part
number.
number.
RAID Controller Notes
The LSI-2008 is an eight port, 6Gb/s SAS/SATA RAID On-a-Chip (ROC) VLSI IC. The LSI-2008 ROC provides a
x8 PCIe Gen2 interface, which is connected as x4 on the B230 server board.
The LSI-2008 SAS/SATA Controller is embedded on the motherboard and supports the following features:
●
RAID 0, 1
LSI-2008 Flash ROM
The LSI-2008 requires a minimum of 8Mbyte Flash ROM configured for 8-bit I/O. The Flash ROM contains code for
the System Optional BIOS, which is needed for booting the RAID array, and also RAID firmware for the embedded
CPU.
Contents:
© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 13 of 15