Cisco Cisco TelePresence MX700 Riferimenti tecnici

D15335.03

 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.1, APRIL 2016. 

Copyright © 2016 Cisco Systems, Inc. All rights reserved. 

54

Cisco TelePresence MX700 and MX800

API Reference Guide

xConfiguration Conference Encryption Mode

Define the conference encryption mode. A padlock with the text "Encryption On" or 

"Encryption Off" displays on screen for a few seconds when the conference starts.

NOTE: If the Encryption Option Key is not installed on the video system, the encryption mode is 

always Off.

Requires user role: ADMIN
Default value: BestEffort

USAGE:

xConfiguration Conference Encryption Mode: 

where

: Off/On/BestEffort
Off: The system will not use encryption.

On: The system will only allow calls that are encrypted.

BestEffort: The system will use encryption whenever possible. 

> In Point to point calls: If the far end system supports encryption (AES-128), the call will 

be encrypted. If not, the call will proceed without encryption. 

> In MultiSite calls: In order to have encrypted MultiSite conferences, all sites must 

support encryption. If not, the conference will be unencrypted.

xConfiguration Conference FarEndControl Mode

Lets you decide if the remote side (far end) should be allowed to select your video sources and 

control your local camera (pan, tilt, zoom).

Requires user role: ADMIN
Default value: On

USAGE:

xConfiguration Conference FarEndControl Mode: 

where

: Off/On
Off: The far end is not allowed to select your video sources or to control your local 

camera (pan, tilt, zoom).

On: Allows the far end to be able to select your video sources and control your local 

camera (pan, tilt, zoom). You will still be able to control your camera and select your 

video sources as normal.

xConfiguration Conference MaxReceiveCallRate

Define the maximum receive bit rate to be used when placing or receiving calls. Note that this 

is the maximum bit rate for each individual call; use the Conference MaxTotalReceiveCallRate 

setting to set the aggregated maximum for all simultaneous active calls.

Requires user role: ADMIN
Default value: 6000

USAGE:

xConfiguration Conference MaxReceiveCallRate: 

where

: Integer (64..6000)

The maximum receive call rate (kbps).

xConfiguration Conference MaxTransmitCallRate

Define the maximum transmit bit rate to be used when placing or receiving calls. Note that this 

is the maximum bit rate for each individual call; use the Conference MaxTotalTransmitCallRate 

setting to set the aggregated maximum for all simultaneous active calls.

Requires user role: ADMIN
Default value: 6000

USAGE:

xConfiguration Conference MaxTransmitCallRate: 

where

: Integer (64..6000)

The maximum transmitt call rate (kbps).

Introduction

About the API

xConfiguration

Appendices

xCommand

xStatus



xConfiguration