Cisco Cisco TelePresence MX700 Guida All'Installazione

D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved. 

www.cisco.com

22

Configuring IP

Your video conference system supports both IP version 4 

(IPv4) and IP version 6 (IPv6).

In both cases, the IP parameters can be assigned 

automatically by the network, or you can set everything 

manually. 

If you want to set the parameters manually please 

contact your network administrator to obtain the required 

parameters.

If an IP address is already assigned to your system, you will 

find the current IPv4 and/or IPv6 address on the System 

Information page:

Go to 

.

The IPv4 Address and/or IPv6 Address of the system 

is shown in the NETWORK

section on the System 

Information page.
Press

 (the right most function key) to exit.

1.  Select IP version

i.  Go to 

.

ii. Select 

or

 in the 

 drop down list 

according to your requirement. 

2.  Select automatic or manual IP assignment

i.  Go to 

.

ii. Select 

 (IPv4) or 

 (IPv6) in the 

 drop down list if you want automatic IP 

assignment; select 

 if you want to set the IP 

addresses manually.

iii. Navigate to 

 to save the change, or 

 to leave 

without saving. Press 

 

( ) 

to confirm.

3.  Set the IP addresses

Set the remaining IP settings according to the table to 

the right. The actions required depend on the IP version 

and IP assignment method you selected in the previous 

steps.

4.  Return to the main menu

Press 

(   )

to return to the home menu.

IP assignment

IP version

The IP configuration is complete.

a. Go to 

 and enter the 

, 

, 

, and 

. 

a. Go to Configure, and set 

 to 

or

 according to your preference. 

1 

b. Navigate to 

 to save the change, or 

 to leave without saving.

a. Go to Configure, and enter the 

 

and 

.

b. Set 

 to 

 or 

 according to 

your preference. 

1

c. Navigate to 

 to save the change or 

 

to leave without saving.

1

 DHCP Options:  

      Off: All IP parameters, except the IP address and gateway, must be set manually.  
            Please refer to the Administrator Guide for your product for details about all settings.  
      On: The IP parameters, like the DNS and NTP server addresses, will be obtained automatically from the network.

Always save the new value when you change a

setting

•  Drop down list selection: Navigate to the correct 

value and press the 

( )

 key to save, or press 

the left arrow key   to leave without saving.

•  Text entry in an input field: Enter the text, navigate 

to 

 to save the change, or navigate to 

 to leave without saving; then press  

 

( ) 

to confirm.

User interfaces

Introduction

Configuration

Table of contents

Appendices

Configuration