Cisco Cisco TelePresence MX700 Guida All'Installazione
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
23
GettinG started Guide
remote control and on-screen menu
Configuring H.323 and SIP
To get online and ready to place and receive calls, your
system must be set up properly. Your system will use either
the H.323 protocol or the SIP protocol for video calls.
NOTE:
Contact your system administrator, or service
provider, for information about the network settings.
For networks administered through Cisco TMS (Cisco
TelePresence Management Suite) your Cisco TMS
administrator will help you to get online.
H.323
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to
Home > Settings > Administrator settings >
Advanced configuration > H323 > Profile 1
.
2. Go to
H323Alias
and enter the
E164 number
and
Id
in
the corresponding input fields.
3. If you want the system to obtain the H.323 gatekeeper
address automatically, select
Auto
in the
Gatekeeper
discovery
drop down list; if you want to enter the
address manually, select
Manual.
If set to
Manual
enter the
Gatekeeper address
in the
corresponding input field.
4. If the H.323 gatekeeper requires authentication and
you want your system to authenticate itself to the
gatekeeper, select
ON
in the
Authentication mode
drop
down list; otherwise select
OFF.
If set to
On
enter the
Login name
and
Password
in the
corresponding input fields.
5. Go to
Home > Settings > Administrator settings >
System Information
and verify the H323 settings.
If you successfully registered to a Gatekeeper the
Status
will show
Registered
in the H323 section.
6. Press
Home
( )
to exit.
Please check the
Administrator guide
for your product if you
want to change the other H.323 settings.
SIP
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to
Home > Settings > Administrator settings >
SIP Settings > Profile 1
.
2. Go to
URI
and enter the SIP URI in the corresponding
input field.
3. Select your preferred
Default transport
protocol in the
drop down list. If you select
Auto
the system will first try
to connect using TLS, then TCP, and finally UDP.
4. Select your preferred proxy
Type
in the drop down list.
The default type is
Standard
.
5. Go to
Proxy 1.
If you want the system to obtain the
SIP proxy address automatically, select
Auto
in the
Proxy discovery
drop down list; if you want to enter the
address manually, select
Manual
.
If set to
Manual
enter the
Proxy address
in the
corresponding input field.
6. If the SIP proxy requires authentication you must enter a
login name and password to authenticate your system.
Go to
Authentication 1
and enter the
LoginName
and
Password
in the corresponding input fields.
7. Go to
Home > Settings > Administrator settings >
System Information
and verify the SIP settings.
If you successfully registered to a SIP server the
Status
will show
Registered
in the SIP section.
8. Press
Home
( )
to exit.
Please check the
Administrator guide
for your product if you
want to change the other SIP settings.
Save the new value when you change a setting
• Drop down list selection: Navigate to the correct
value and press the
OK
( )
key to save, or press
the left arrow key to leave without saving.
• Text entry in an input field: Enter the text, navigate
to
Ok/Save
to save the change, or navigate to
Cancel
to leave without saving; then press
OK
( )
to confirm.
User interfaces
Introduction
Configuration
Table of contents
Appendices
Configuration