Cisco Cisco TelePresence MX700 Manuale Di Manutenzione
About the phone security profile
Security profiles must be defined when using secure
(encrypted) communication, else use the non-secure profile.
Note the following:
• CUCM must operate in mixed mode (cluster security
• CUCM must operate in mixed mode (cluster security
mode) to enable secure communication.
• Define one device security profile for each endpoint type.
• If you want to allow several authentication modes for the
• If you want to allow several authentication modes for the
same endpoint type, define one profile for each mode.
See the CUCM Security Guide for further information:
About non-secure and secure profiles
TelePresence endpoints support
Non-secure
and
Encrypted
modes. They do not support Authenticated mode. When
endpoints are connected to CUCM by Expressway, they
support only
Non-secure
mode.
Non-secure profile
The non-secure endpoints use the
predefined non-secure
profile
. See
13.
Secure (Encrypted) profile
When configuring a secure device for the first time, you can
copy a predefined non-secure profile to use as a template.
This method is used in this section.
You may also choose
Add New
, and then choose the type of
TelePresence endpoint for the
phone security profile
.
The page content is the same using either method, but the
default values may vary.
Editing a security profile
The non-secure endpoints
use the predefined non-
secure profile. No action
required.
Creating a security profile
When registering a
secure
device
for the first time,
copy the predefined non-
secure profile to use as a
template.
Cisco TelePresence Endpoints and Cisco Unified Communications Manager
Deployment Guide
D15336.01 Deployment gude for TelePresence Endpoints on CUCM, DECEMBER 2015.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
11
Contents
Introduction
CUCM configuration
Endpoint configuration
Appendices
Contact
CUCM configuration