Cisco Cisco Firepower Management Center 2000 Guida All'Installazione

      

  Installing the Firepower Management Center

Firepower Management Center Getting Started Guide

If your appliance has redundant power supplies, attach power cords to both power supplies and plug them 
into separate power sources.

Turn on the appliance. 



If you are connecting a computer directly to the appliance’s physical management interface to set up the 
appliance, continue to 

.



If you are using a keyboard and monitor to set up the appliance, continue to 

Management Center Setup Using the Management Interface

Using the supplied Ethernet cable, connect the network interface on the preconfigured computer directly to 
the management interface on the appliance. 

Confirm that the link LED is on for both the network interface on the local computer and the management 
interface on the appliance. 

Use a web browser to navigate to the appliance’s default IP address:

https:// 192.168.45.45

The login page appears.

Log in using 

admin

 as the username and 

Admin123

 as the password. 



Complete the setup process using the procedures in 

.

Management Center Setup Using a Keyboard and Monitor (KVM)

Using the supplied Ethernet cable, connect the management interface on the back of the appliance to a 
protected management network. 

Connect the monitor to the VGA port and the keyboard to one of the USB ports.

Log into the command line interface using 

admin

 as the username and 

Admin123

 as the password. Note that 

the password is case-sensitive.

Run the following script:

sudo /usr/local/sf/bin/configure-network

The following prompt (appended with the current value) appears:

Management IP address?

Enter the IP address you want to assign to the management interface or press Enter to accept the current 
value. For example:

10.2.2.20

The following prompt (appended with the current value) appears:

Management netmask?