Cisco Cisco Firepower Management Center 2000 Guida Informativa
Cisco Systems, Inc.
www.cisco.com
www.cisco.com
78-100730-01A0
Installing Round Hole Adapters for Square Hole
Rack Slides for the Cisco Firepower 7100 Series
Rack Slides for the Cisco Firepower 7100 Series
Last Updated: May 28, 2015
This document describes how to install round hole rack adapters that can be used to adapt the
square-hole-only sliding rail kits that are supplied with the Cisco Firepower 7100 Series devices. The
document contains the following sections:
square-hole-only sliding rail kits that are supplied with the Cisco Firepower 7100 Series devices. The
document contains the following sections:
•
•
•
•
Warning
This document applies only to sliding rail kits that have yellow square hole mount retention pieces.
Use with other racks and slides is not supported and may cause injury or damage to equipment.
Use with other racks and slides is not supported and may cause injury or damage to equipment.
Supplied Components
The adapter kit in
contains all items needed to adapt one sliding rail kit needed to mount one
Firepower 7100 Series device in a rack. Your kit should look similar to the kit in
Table 1
Round-to-Square Hole Rack Adapter Kit for Firepower 7100 Devices
Adapter Kit
Contents
FP7100-RND-ADPT=
4 x adapter brackets
8 x M5-0.8mm x 9.52mm Philips flat head screws
4 x Hex standoffs
4 x 8-32 x 5/8 inch (15.87mm) Philips flat head screws
2 x washers