Cisco Cisco Firepower Management Center 2000 Guida Informativa
2
Installing Round Hole Adapters for Square Hole Rack Slides for the Cisco Firepower 7100 Series
78-100730-01A0
Applicable Racks
Figure 1
Round-to-Square Hole Rack Adapter Kit for Firepower 7100 Devices
Applicable Racks
The adapter kit is applicable for use on racks with a rail (vertical mounting flange) thickness of 0.125”
(3.18mm) or less. The rack hole pattern must comply with EIA-310-D (or later.) The rails must be
threaded with 10-32 holes to use the provided screws. The adapter holes will clear M8 and 12-24 sized
screws.
(3.18mm) or less. The rack hole pattern must comply with EIA-310-D (or later.) The rails must be
threaded with 10-32 holes to use the provided screws. The adapter holes will clear M8 and 12-24 sized
screws.
Warning
This kit does not work with Chatsworth /CPI racks that use the C shaped beams due to interference
with the inner part of the C-Beam and the shoulder of the slide bracket structure (see
with the inner part of the C-Beam and the shoulder of the slide bracket structure (see
Figure 2
Chatsworth/CPI Rack Interference
Note
Cage nuts and Tinnerman style (clip) nuts are NOT supported. Nuts of any kind behind the rail are NOT
supported.
supported.
Note
Use of the adapters increases both the minimum and the maximum front-to-back rail spacing by
approximately 1” (26mm.)
approximately 1” (26mm.)