Cisco Cisco IOS Software Release 12.4(2)XB6
4
Release Notes for the Cisco Broadband Wireless Gateway 2.1 for Cisco IOS Release 12.4(24)YG1
OL-21495-01
System Requirements
Determining the Software Version
To determine the version of Cisco IOS software running on your router, log in to the router and enter the
show version EXEC command.
show version EXEC command.
SUP Backward Compatibility
The BWG Release 2.1 on the Cisco 7600 hardware platform requires SUP software version SRE.
However, BWG Release 2.1 will also work with limited features with an earlier SUP software version
SRD.
However, BWG Release 2.1 will also work with limited features with an earlier SUP software version
SRD.
In order to make BWG 2.1work with an earlier version of SUP-SRD, configure the following hidden CLI
at the global configuration mode:
at the global configuration mode:
With SUP-SRD, BWG Release 2.1 will primarily be used for Cisco-R6, PMIP, and other BWG1.x
features.
features.
Note
If you use the SUP-SRD image, the following features in BWG Release 2.1 are not supported:
•
SLB Stickiness Support
•
NWG R6 in SLB-mode.
Features Introduced Before Cisco IOS Release 12.4(24)YG1
The following features were introduced and supported on the BWG prior to Cisco IOS Release
12.4(24)YG1:
12.4(24)YG1:
•
Support for Proxy Mobile IPv4 (PMIPv4)
•
AAA-Based Hot-lining (CoA)
•
DSCP Marking
•
WiMAX NWG Specification (1.2.2) Compliance
•
Accounting Start Response
•
SLB Stickiness Support
•
AAA Packet of Disconnect Message (PoD)
•
AAA-based Static IP Address Provisioning
•
Lawful Intercept
•
Hitless Software Upgrade
•
Redundancy DHCP server
•
Host Based Accounting
•
Mobile to Mobile Traffic Steering
Command
Purpose
Step 1
router(config)# wimax agw sup-backward-compatible
Specifies that the BWG will work with the SRD
Supervisor image.
Supervisor image.