Cisco Cisco IOS Software Release 12.4(22)XR

router(config)# ip mobile foreign-agent mn-identifier calling-station-id

To remove the configuration, use:

router(config)# no ip mobile foreign-agent mn-identifier calling-station-id 

Configure the following CLI commands also.

To send 3GPP2 CLID NVSE in MIP RRQ:

router(config)# [no] cdma pdsn attribute send a1 mip-rrq

To send CT CLID NVSE in MIP RRQ:

Router(config)# [no] cdma pdsn attribute vendor 20942 send a1 mip rrq

To send CLID VSA in FA-CHAP:

Router(config)# [no] cdma pdsn attribute send a1 fa-chap

Ensure that you configure this command only when there are no sessions.

The proxy MIP changes for the IS-835 feature, introduced in Cisco PDSN Release 5.1, supports the draft 
version of 3GPP2 X.S0061-0 Version 1.0, entitled Network PMIP Support for PMIPv4. 

The following are different PMIP-related attributes that are used at the AAA server level to indicate 
different functionalities of PMIP:

The network-PMIP-NAI VSA specifies the NAI to be used by the access gateway (AGW) for network 
PMIP binding between AGW and HA. The network-PMIP-NAI attribute is included in the RADIUS 
access-accept message if the AGW supports network PMIP and the AT is authorized for network 
PMIP-based mobility. 

The network-PMIP NAI attribute is received from the AAA server only in the access-reply message. 
Also, this attribute specifies the NAI for mobile node for a PMIP call and is used as the NAI. 
Cisco PDSN accepts this attribute only if you enable the PMIP-based mobility capability command 
cdma pdsn attribute send 3gpp2 pmip-indicator auth-req from the CLI. Otherwise, the call is 
rejected.

The PMIP-based mobility capability VSA indicates that the AGW supports network PMIP to the AAA 
server. A new PMIP-based mobility capability CLI command, cdma pdsn attribute send 3gpp2 
pmip-indicator auth-req, is introduced in Cisco PDSN Release 5.1.