Cisco Cisco IOS Software Release 12.2(35)SE
5
Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(46)SE
OL-16968-01
Upgrading the Switch Software
Finding the Software Version and Feature Set
The Cisco IOS image is stored as a bin file in a directory that is named with the Cisco IOS release.
A subdirectory contains the files needed for web management. The image is stored on the system board
flash device (flash:).
A subdirectory contains the files needed for web management. The image is stored on the system board
flash device (flash:).
You can use the show version privileged EXEC command to see the software version that is running on
your switch. The second line of the display shows the version.
your switch. The second line of the display shows the version.
Note
Although the show version output always shows the software image running on the switch, the model
name shown at the end of this display is the factory configuration (IP base feature set or IP services
feature set) and does not change if you upgrade the software license.
name shown at the end of this display is the factory configuration (IP base feature set or IP services
feature set) and does not change if you upgrade the software license.
You can also use the dir filesystem: privileged EXEC command to see the directory names of other
software images that you might have stored in flash memory.
software images that you might have stored in flash memory.
Deciding Which Files to Use
The upgrade procedures in these release notes describe how to perform the upgrade by using a combined
tar file. This file contains the Cisco IOS image file and the files needed for the embedded device
manager. You must use the combined tar file to upgrade the switch through the device manager. To
upgrade the switch through the command-line interface (CLI), use the tar file and the archive
download-sw privileged EXEC command.
tar file. This file contains the Cisco IOS image file and the files needed for the embedded device
manager. You must use the combined tar file to upgrade the switch through the device manager. To
upgrade the switch through the command-line interface (CLI), use the tar file and the archive
download-sw privileged EXEC command.
lists the filenames for this software release.
Note
To use the IPv6 routing and IPv6 ACL features on the Cisco Catalyst Blade Switch 3120 for HP, you
must purchase the advanced IP services software license from Cisco.
must purchase the advanced IP services software license from Cisco.
The universal software images support multiple feature sets. Use the software activation feature to
deploy a software license and to enable a specific feature set. For information about software activation,
see the Cisco Software Activation for HP document on Cisco.com:
deploy a software license and to enable a specific feature set. For information about software activation,
see the Cisco Software Activation for HP document on Cisco.com:
Table 4
Cisco IOS Software Image Files
Filename
Description
cbs31x0-universal-tar.122-46.SE.tar
Cisco Catalyst Blade Switch 3120 for HP universal image and device manager
files. This image has all the supported features that are enabled by the software
license installed on the switch.
files. This image has all the supported features that are enabled by the software
license installed on the switch.
cbs31x0-universalk9-tar.122-46.SE.tar
Cisco Catalyst Blade Switch 3120 for HP universal cryptographic image and
device manager files. This image has the Kerberos, SSH, SSL, and SNMPv3 in
addition to the features supported in the universal image.
device manager files. This image has the Kerberos, SSH, SSL, and SNMPv3 in
addition to the features supported in the universal image.