Cisco Cisco IOS Software Release 12.2(27)SBC

The CISCO-CBP-TARGET-MIB contains the following unsupported scalar object:

ccbptPolicyNext—Indicates the next available value of ccbptPolicyId that can be used to create a 
new conceptual row in the ccbptTargetTable.  If no available identifier exists, this object has a value 
of 0. This object is read-only and is unsupported.

The CISCO-CBP-TARGET-MIB contains the following supported scalar object:

ccbptTargetTableLastChange—Shows the value of sysUpTime at the time of the last addition or 
deletion of an entry in the ccbptTargetTable. If the number of entries is unchanged since the last 
reinitialization of the local network management system, the value of this object is 0. This object is 
read-only and is supported.

There are no notifications in the CISCO-CBP-TARGET-MIB.

In deployments where service policies are applied to several thousand interfaces, obtaining QoS 
statistics and configuration information on a per interface or target basis is difficult using the 
organization of the CISCO-CLASS-BASED-QOS-MIB.  You must perform a linear search of the 
cbQosServicePolicyTable within the MIB to find the corresponding cbQosPolicyIndex and then search 
for the configuration and statistics for the service policy applied to the interface (target). 

The CISCO-CBP-TARGET-MIB offers a direct mapping from the target to the service policy applied to 
the target and provides the configuration information for that same service policy.

There is no special way to configure this feature. For information on SNMP and QoS configuration tasks 
and examples, see the 

, Release 12.4T, the 

, Release 12.4T, respectively.

This section provides the following configuration example: