Cisco Cisco IPS 4255 Sensor
16
Release Notes for Cisco Intrusion Prevention System 6.0(4)E2
OL-20146-01
After Upgrading to Cisco IPS 6.0(4)E2
For More Information
•
For more information on Cisco service contracts, see
.
•
For the procedure for locating software on Cisco.com and obtaining an account with cryptographic
privileges, see
privileges, see
After Upgrading to Cisco IPS 6.0(4)E2
This section provides information about what to do after you install IPS 6.0(4)E2. It contains the
following topics:
following topics:
•
•
•
•
Comparing Configurations
Compare your backed up and saved 6.0(4)E1 configuration with the output of the show configuration
command after upgrading to 6.0(4)E2 to verify that all the configuration has been properly converted.
command after upgrading to 6.0(4)E2 to verify that all the configuration has been properly converted.
Caution
If the configuration is not properly converted, check the list of caveats, or check Cisco.com for any
upgrade issues that have been found. Contact the TAC if no DDTS refers to your situation.
upgrade issues that have been found. Contact the TAC if no DDTS refers to your situation.
For More Information
For the list of IPS 6.0(4)E2 caveats, see
.
SSL Certificate
If necessary, import the new SSL certificate for the upgraded sensor in to each tool being used to monitor
the sensor.
the sensor.
For More Information
For the CLI procedure for importing a new SSL certificate, refer to
. For the IDM
procedure, refer to
.