Cisco Cisco IPS 4255 Sensor Guida All'Installazione
10
Removing and Installing Interface Cards in Cisco IPS-4260 and IPS 4270-20
78-19056-01
Installing Interface Cards in IPS-4260
Step 8
Remove the card carrier by pulling up on the two blue release tabs. Use equal pressure and lift the card
carrier out of the chassis.
carrier out of the chassis.
Step 9
With a screw driver, remove the screw from the desired slot cover.
Step 10
Remove the slot cover by pressing on it from inside the chassis.
If the card is full length, use a screw driver to remove the blue thumb screw from the card support at the
back of the card carrier.
back of the card carrier.
Step 11
Carefully align the PCI card with the PCI-Express connector and alignment grooves for the appropriate
slot. Apply firm even pressure until the card is fully seated in the connector.
slot. Apply firm even pressure until the card is fully seated in the connector.
Step 12
Reinstall the slot cover screw to hold the card to the carrier. If necessary, reinstall the card support at the
back of the card carrier.
back of the card carrier.
Step 13
Replace the card carrier in the chassis.
Step 14
Replace the chassis cover.
153312
!
!
!
!
190471