Cisco Cisco IPS 4255 Sensor Guida All'Installazione
9
Removing and Installing Interface Cards in Cisco IPS-4260 and IPS 4270-20
78-19056-01
Installing Interface Cards in IPS-4260
For More Information
For the procedure for removing IPS-4260 from a rack, refer to “Installing IPS-4260,” in
.
Installing and Removing Interface Cards
IPS-4260 has 6 expansion card slots, three full-height and three half-height slots. You can install the
optional network interface cards in the two top full-height slots, slots 2 and 3. IPS-4260 supports up to
two network interface cards.
optional network interface cards in the two top full-height slots, slots 2 and 3. IPS-4260 supports up to
two network interface cards.
Note
IPS 4260 supports only one 10GE fiber interface card, which you can install in either of the supported
slots (slots 2 and 3).
slots (slots 2 and 3).
Note
We recommend that you install the 4GE bypass interface card in slot 2 if you are installing only one 4GE
bypass card. This improves accessibility to the RJ45 cable connectors.
bypass card. This improves accessibility to the RJ45 cable connectors.
To install and remove PCI cards, follow these steps:
Step 1
Log in to the CLI.
Step 2
Prepare IPS-4260 to be powered off:
sensor# reset powerdown
Wait for the power down message before continuing with Step 3.
Note
You can also power down IPS-4260 using IDM or IME.
Step 3
Power off IPS-4260.
Step 4
Remove the power cable and other cables from IPS-4260.
Step 5
If rack-mounted, remove IPS-4260 from the rack.
Step 6
Make sure IPS-4260 is in an ESD-controlled environment.
Step 7
Remove the chassis cover.