Cisco Cisco 4100 Series Wireless LAN Controller Riferimenti tecnici
3/22/05
config ap
OL-7427-01 Rev 1
Defaults
(None.)
Example
>config advanced timers eap-timeout 10
Related Commands
show advanced timers
CONFIG AP COMMANDS
config ap
Use the following config ap commands:
•
•
•
•
config ap enable
•
•
•
•
•
•
config ap primary-base
•
•
•
•
•
•
•
•
config ap add
config ap add
To add a Third-Party access point, use the config ap add command. This command only applies to
Third-Party APs, as Cisco 1000 Series lightweight access points are automatically detected and added
to the Cisco Wireless LAN Controller.
Third-Party APs, as Cisco 1000 Series lightweight access points are automatically detected and added
to the Cisco Wireless LAN Controller.
>config ap add <MAC address> <port> [enable/disable] <ip-addr>
Syntax
config
Configure parameters.
ap
Access point.
add
Add a Third-Party AP.
<MAC address>
MAC address of the Third-Party AP.
<port>
Port number of the Cisco Wireless LAN Controller
where AP is connected.
where AP is connected.
[enable/disable]
Enable or disable the port
<ip-addr>
IP address
Defaults
(none)