Cisco Cisco 5520 Wireless Controller Guida Alla Progettazione
1-31
Book Title
OL-xxxxx-xx
Chapter 1 Cisco Adaptive wIPS Management Deployment Guide, Release 8.0
Cisco Adaptive wIPS Introduction
b.
Change AP Mode to Monitor.
c.
Enable Enhanced WIPS Engine.
d.
Change Monitor Mode Optimization to WIPS.
e.
Click Save at the bottom of the page.
f.
Click OK when prompted to reboot the AP.
Repeat this for each AP that is configured to wIPS monitor mode.
Configuring Access Points to AP3600 Local Mode and the WSM Module
This mode is only available for a 3600 series Access Point (AP) with a WSM module installed.
To configure APs to AP3600 local mode plus the WSM module:
Step 1
Configure the AP to local mode:
Enter the AP configuration menu in PI via Operate > Device Group > Device Type > Unified AP
and click on the Access Point’s name, then Configuration.
and click on the Access Point’s name, then Configuration.