Cisco Cisco 5520 Wireless Controller Guida Alla Progettazione
1-32
Book Title
OL-xxxxx-xx
Chapter 1 Cisco Adaptive wIPS Management Deployment Guide, Release 8.0
Cisco Adaptive wIPS Introduction
a.
Change AP Mode to Local.
b.
Enable Enhanced WIPS Engine.
c.
Change AP Sub Mode to WIPS.
d.
Click Save at the bottom of the page.
e.
Click OK when prompted to reboot the AP.
Repeat this for each AP that is configured to local mode.
Configuring wIPS Profiles
By default, the MSE and corresponding wIPS Access Points inherit the default wIPS profile from PI.
This profile comes pre-tuned with a majority of attack alarms enabled by default and will monitor attacks
against Access Points within the same RF-Group as the wIPS Access Points. In this manner, the system
comes pre-setup to monitor attacks against a deployment model that utilizes an integrated solution in
which both the WLAN infrastructure and wIPS Access Points are intermixed on the same controller.
This profile comes pre-tuned with a majority of attack alarms enabled by default and will monitor attacks
against Access Points within the same RF-Group as the wIPS Access Points. In this manner, the system
comes pre-setup to monitor attacks against a deployment model that utilizes an integrated solution in
which both the WLAN infrastructure and wIPS Access Points are intermixed on the same controller.
Note
Some of the steps below are marked as Overlay-Only and are only to be undertaken when deploying the
Adaptive wIPS solution to monitor an existing WLAN Infrastructure such as an autonomous or
completely separate controller-based WLAN.
Adaptive wIPS solution to monitor an existing WLAN Infrastructure such as an autonomous or
completely separate controller-based WLAN.
To configure wIPS profiles:
Step 1
Navigate to wIPS Profiles:
From the top-level PI menu, click Design > Configuration > Wireless Configuration > wIPS
Profiles.
Profiles.
Step 2
Create a new Profile: