Cisco Cisco TelePresence MX700 Guida All'Installazione

D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved. 

www.cisco.com

22

Setting date, time and location

(when not set by a provisioning system)

When setting up your video conference system, you 

should check that the date and time settings are correct. 

Among other things this information is used to time stamp 

messages transmitted to gatekeepers and other network 

elements.

The time and date is shown in the top right corner of the 

main display.

1. Go to 

.

2. Select 

 or 

 in the 

drop down list as you prefer.

3. Select 

, 

 or 

 in the 

drop down list as you prefer.

4. Select your time zone in the 

 drop down list.

5. Select 

, 

 or 

in the 

 drop down 

list as you prefer. 

1

If you select 

, also enter the 

address 

in the corresponding input field.
If you select 

also select the correct value for 

, 

, 

 and 

 in the corresponding drop down 

lists.

6. Press 

(   )

to exit.

1

 NTP mode: 

      Auto:     The time is regularly updated using an NTP server. The  
                   NTP server address is automatically obtained from the  
                   network (DHCP). 
      Manual: The time is regularly updated using an NTP server. You 
                   must manually enter the NTP server address. 
      Off:       You must set the time manually. The time is not  
                   updated automatically.

Save the new value when you change a setting

•  Drop down list selection: Navigate to the correct 

value and press the 

( )

 key to save, or press 

the left arrow key   to leave without saving.

•  Text entry in an input field: Enter the text, navigate 

to 

 to save the change, or navigate to 

 to leave without saving; then press the 

 

( ) key 

to confirm.

Back to task overview

User interfaces

Introduction

Configuration

Table of contents

Appendices

Configuration