Cisco Cisco TelePresence MX700 Dépliant

Cisco

333: I installed a video camera to the video input number 2 on my C90 using component video,

now I am not able to get any video when I activate this source. Why?

363: Is transcoding supported for the H.239/dual stream?

524: Are there any shortcuts on the TRCV remote control?

528: Which resolutions do the video systems support at 60 fps?

545: Can I deploy endpoints from outside the enterprise network, for example, from a home

office or remote office without VPN connection

558: How do I record my video calls?

609: My computer is connected to the DVI-I input of the EX90, but the desktop is not displayed

on the screen. Why?

610: What resolutions does the EX90 support on the DVI-I PC-screen input?

611: Can I run MultiSite on EX and MX video systems?

617: Which provisioning mode do the codes support?

620: Can I send content on the EX90 using HDMI 1 as input source?

622: Can I use the MX and EX systems as a USB hub?

630: I have the C40 DVI output configured as a second monitor, but when connecting to the DVI-I

output on the C40 codec, nothing is displayed on the screen, why?

631: When connecting to the second HDMI output on the Cisco TelePresence Codec C20, C40,

SX20 or EX90, nothing is displayed on the screen, why?

667: My computer is connected to the DVI-I input, but the desktop is not displayed on the screen.

694: How do I setup a Cisco TelePresence video system so that I am not disturbed by incoming

calls when I am already in a call?

695: Which configurations on my video system require a reboot to take effect?

697: How can I set up self view in full screen mode on my secondary monitor?

701: Which systems do not support H.323?

300: The monitor does not go to standby mode when it is connected to a codec.

302: How do I change the output for my On Screen Display (OSD) from HDMI1 to another output

when the system is used with the TRCV remote control?

303: My C Series Codec does not seem to boot up (no video is displayed on the monitor), why?

313: I changed the video output on my codec to a new resolution not supported by the monitor,

how do I revert this?

318: My Pioneer plasma monitor does not display the image correctly from my codec. Why?

319: My monitor displays the image from my codec outside of the monitor frame, why?

325: There is no audio coming out from my codec when it is connected to my monitor with a

HDMI cable, why?

609: My computer is connected to the DVI-I input of the EX90, but the desktop is not displayed

on the screen. Why?

610: What resolutions does the EX90 support on the DVI-I PC-screen input?

630: I have the C40 DVI output configured as a second monitor, but when connecting to the DVI-I

output on the C40 codec, nothing is displayed on the screen, why?

662: What should I do before contacting TAC?

667: My computer is connected to the DVI-I input, but the desktop is not displayed on the screen.

688: How can I use a dedicated monitor for showing presentations only?

689: How do I select which monitor output is primary and which is secondary?

699: Can the SX80 DVI-I output support Composite or S-Video?

Monitor

Cisco TelePresence TC Endpoints

D14865.03 TC Endpoints Knowledge Base Articles | APRIL 2015

Copyright © 2011–2013 Cisco Systems, Inc. All rights reserved.

7

Knowledge Base Articles

Contents

Introduction

Questions

Contact

Questions and answers

Appendices

Questions and answers