Cisco Cisco Aironet 1810w Access Point Guida All'Installazione

To mount the AP on a wall, follow these steps:

Fasten the spacer box (AIR-AP1810W-KIT=) to the wall, with the side having the Mount 
Arrows Up label facing outwards, and the box oriented vertically as indicated by the arrows. 
See 

.

However, if you have a junction box on the wall, then you do not need to use a spacer box. 
You may fasten the wall-mount bracket directly to the spacer box. The spacer box can be used 
on a wall or on an electrical junction box.

The spacer box dimensions are given in 

Fasten the wall-mount bracket (AIR-AP-BRACKET-W2) to the wall, or to the spacer box, or 
to a junction box as you require. Ensure that the side having the Mount Arrows Up label 
facing outwards, and the bracket oriented vertically as indicated by the arrows. See 

The wall-bracket dimensions are given in 

Connect the power and network cables to the AP.

If you are unable to connect a PoE cable to the port on the back of the AP, then:

On the back of the AP, use an RJ45 jumper cable to connect the PoE port to the Pass-Through 
port. This jumper cable is available as part of the Spacer kit AIR-AP1810W-KIT= and Cradle 
kit AIR-OEAP1810-CRD=.

Connect to the PoE supply cable to the Pass-Through port on the base of the AP.

This sends the power internally from the Pass-Through port on the base, to the Pass-Through 
port on the back, and then though the jumper cable into the PoE port on the back.

Mount the AP onto the wall-mount bracket. 

Fasten the AP to the bracket using the Torx security screw. Cover it with the mylar label.