Cisco Cisco Aironet 1810w Access Point 安装指南
19
To mount the AP on a wall, follow these steps:
Step 1
Fasten the spacer box (AIR-AP1810W-KIT=) to the wall, with the side having the Mount
Arrows Up label facing outwards, and the box oriented vertically as indicated by the arrows.
See
Arrows Up label facing outwards, and the box oriented vertically as indicated by the arrows.
See
.
However, if you have a junction box on the wall, then you do not need to use a spacer box.
You may fasten the wall-mount bracket directly to the spacer box. The spacer box can be used
on a wall or on an electrical junction box.
You may fasten the wall-mount bracket directly to the spacer box. The spacer box can be used
on a wall or on an electrical junction box.
The spacer box dimensions are given in
Step 2
Fasten the wall-mount bracket (AIR-AP-BRACKET-W2) to the wall, or to the spacer box, or
to a junction box as you require. Ensure that the side having the Mount Arrows Up label
facing outwards, and the bracket oriented vertically as indicated by the arrows. See
to a junction box as you require. Ensure that the side having the Mount Arrows Up label
facing outwards, and the bracket oriented vertically as indicated by the arrows. See
The wall-bracket dimensions are given in
Step 3
Connect the power and network cables to the AP.
If you are unable to connect a PoE cable to the port on the back of the AP, then:
a.
On the back of the AP, use an RJ45 jumper cable to connect the PoE port to the Pass-Through
port. This jumper cable is available as part of the Spacer kit AIR-AP1810W-KIT= and Cradle
kit AIR-OEAP1810-CRD=.
port. This jumper cable is available as part of the Spacer kit AIR-AP1810W-KIT= and Cradle
kit AIR-OEAP1810-CRD=.
b.
Connect to the PoE supply cable to the Pass-Through port on the base of the AP.
This sends the power internally from the Pass-Through port on the base, to the Pass-Through
port on the back, and then though the jumper cable into the PoE port on the back.
port on the back, and then though the jumper cable into the PoE port on the back.
Step 4
Mount the AP onto the wall-mount bracket.
Step 5
Fasten the AP to the bracket using the Torx security screw. Cover it with the mylar label.