Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Access Control Lists
Applying IP ACLs ▀
Cisco ASR 5000 Series Enhanced Feature Configuration Guide ▄
OL-22983-01
Applying an ACL to Service-specified Default Subscribers
This section provides information and instructions for applying an ACL to the subscriber to be used as the ―default‖
profile by various system services.
profile by various system services.
Important:
It is recommended that all ACLs be configured and verified according to the instructions in the
that the services and subscribers have been previously configured.
Important:
This section provides the minimum instruction set for applying the ACL list to all traffic within a
context. For more information on commands that configure additional parameters and options, refer Subscriber
Configuration Mode Commands chapter in Command Line Interface Reference.
Configuration Mode Commands chapter in Command Line Interface Reference.
To configure the system to provide access control list facility to subscribers:
Step 1
Apply the configured access control list by applying the example configuration in the
Step 2
Verify that ACL is applied properly on interface by following the steps in the
Step 3
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Applying an ACL to Service-specified Default Subscriber
To apply the ACL to a service-specified Default subscriber, use the following configuration: