Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi

Pagina di 1720
show card   
▀  show card table 
 
▄  Cisco ASR 5000 Series Statistics and Counters Reference 
OL-22990-02   
show card table 
Table 128. 
show card table
 Command Output Descriptions 
Field
 
Description
 
Slot 
Displays the chassis slot number and type. The slot type represents the type of card(s) that the slot supports. Possible 
slot types are: 
 
Slots 1 through 7, and 10 through 16: Supports either a Processing Card, or a Telephony Accelerator Card 
(TAC) 
 
Slots 8 and 9: Support Switch Processor Cards (SPCs) or System Management Cards (SMCs) 
 
Slots 40 and 41: Support Redundant Crossbar Cards (RCCs) 
Card 
Type 
Displays the type of card installed. The possible card types supported for this release are: 
 
Packet Accelerator Cards 
 
Packet Services Cards 
 
Switch Processor Cards 
 
System Management Cards 
 
Redundant Crossbar Cards 
Oper 
State 
Displays the operational state of the card. The possible operational states are: 
 
Active: Indicates that the card is an active component that will be used to process subscriber data sessions. 
 
Standby: Indicates that the card is a redundant component. Redundant components will become active through 
manual configuration or automatically should a failure occur. 
 
Offline: Indicates that the card is installed but is not ready to process subscriber data sessions. This could be 
due to the fact that it is not completely installed (i.e. the card interlock switch is not locked, refer to the System 
Installation Guide for information on installing cards in the system) or that its processes have been halted. 
SPOF 
Displays whether or not the component is a single point of failure (SPOF) in the system. If the component is a SPOF, 
then a Yes will appear in this column. If not, a No will be displayed. 
Attach 
Displays the line card that the Processing Cards and SPCs/SMCs are using for network access. 
This column will only be populated for the RCCs in the event that tasks and processes were migrated from an active 
Processing Card to a standby Processing Card. The RCC creates a path from the standby Processing Card to the line 
cards.