Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
show card
▀ show card table
▄ Cisco ASR 5000 Series Statistics and Counters Reference
OL-22990-02
show card table
Table 128.
show card table
Command Output Descriptions
Field
Description
Slot
Displays the chassis slot number and type. The slot type represents the type of card(s) that the slot supports. Possible
slot types are:
slot types are:
Slots 1 through 7, and 10 through 16: Supports either a Processing Card, or a Telephony Accelerator Card
(TAC)
(TAC)
Slots 8 and 9: Support Switch Processor Cards (SPCs) or System Management Cards (SMCs)
Slots 40 and 41: Support Redundant Crossbar Cards (RCCs)
Card
Type
Type
Displays the type of card installed. The possible card types supported for this release are:
Packet Accelerator Cards
Packet Services Cards
Switch Processor Cards
System Management Cards
Redundant Crossbar Cards
Oper
State
State
Displays the operational state of the card. The possible operational states are:
Active: Indicates that the card is an active component that will be used to process subscriber data sessions.
Standby: Indicates that the card is a redundant component. Redundant components will become active through
manual configuration or automatically should a failure occur.
manual configuration or automatically should a failure occur.
Offline: Indicates that the card is installed but is not ready to process subscriber data sessions. This could be
due to the fact that it is not completely installed (i.e. the card interlock switch is not locked, refer to the System
Installation Guide for information on installing cards in the system) or that its processes have been halted.
due to the fact that it is not completely installed (i.e. the card interlock switch is not locked, refer to the System
Installation Guide for information on installing cards in the system) or that its processes have been halted.
SPOF
Displays whether or not the component is a single point of failure (SPOF) in the system. If the component is a SPOF,
then a Yes will appear in this column. If not, a No will be displayed.
then a Yes will appear in this column. If not, a No will be displayed.
Attach
Displays the line card that the Processing Cards and SPCs/SMCs are using for network access.
This column will only be populated for the RCCs in the event that tasks and processes were migrated from an active
Processing Card to a standby Processing Card. The RCC creates a path from the standby Processing Card to the line
cards.
This column will only be populated for the RCCs in the event that tasks and processes were migrated from an active
Processing Card to a standby Processing Card. The RCC creates a path from the standby Processing Card to the line
cards.