Cisco Cisco ASR 5000
LTE Policy Configuration Mode Commands
sgsn-mme ▀
Command Line Interface Reference, StarOS Release 18 ▄
7177
sgsn-mme
This command is used to enable or disable subscriber data optimization in a SGSN-MME combo node.
Product
SGSN
MME
Privilege
Administrator
Mode
Exec > Global Configuration > LTE Policy Configuration
configure > lte-policy
Entering the above command sequence results in the following prompt:
[local]host_name(lte-policy)#
Syntax
[ no ] sgsn-mme subscriber-data-optimization
no
Disables the configured optimization in a SGSN-MME combo node.
subscriber-data-optimization
Enables subscriber data optimization in a SGSN-MME combo node.
Usage
This command is used to configure data optimization in a SGSN-MME combo node. When this command is
configured in a co-located SGSN and MME node, lower memory or CPU utilization and reduced signaling
towards other nodes in network is achieved. This feature is supported by both the S4-SGSN and the Gn-
SGSN. For the feature to apply to a Gn-SGSN, the Gn-SGSN must be configured to connect to an HSS. The
is a licensed Cisco feature. A separate feature license is required. Contact your Cisco account representative
for detailed information on specific licensing requirements. For information on installing and verifying
licenses, refer to the Managing License Keys section of the Software Management Operations chapter in the
System Administration Guide
configured in a co-located SGSN and MME node, lower memory or CPU utilization and reduced signaling
towards other nodes in network is achieved. This feature is supported by both the S4-SGSN and the Gn-
SGSN. For the feature to apply to a Gn-SGSN, the Gn-SGSN must be configured to connect to an HSS. The
is a licensed Cisco feature. A separate feature license is required. Contact your Cisco account representative
for detailed information on specific licensing requirements. For information on installing and verifying
licenses, refer to the Managing License Keys section of the Software Management Operations chapter in the
System Administration Guide
Example
The following command is used to enable subscriber data optimization in a SGSN-MME combo node.
sgsn-mme subscriber-data-optimization