Cisco Cisco Packet Data Gateway (PDG)
Configuring the Evolved Packet Data Gateway
Configuring the System to Perform as an Evolved Packet Data Gateway ▀
ePDG Administration Guide, StarOS Release 18 ▄
103
The
mag-service
command creates the MAG (Mobile Access Gateway) service that communicates with the LMA
(Local Mobility Anchor) service on the P-GW to provide network-based mobility management. The
ipv6 route
command configures a static IPv6 route to the next-hop router. In this configuration, it configures a static route from the
ePDG to the P-GW over the S2b interface. The
ePDG to the P-GW over the S2b interface. The
bind interface
command binds each logical interface to a physical
Ethernet port.
Egress Context and EGTP Service Configuration
Create the Egress context and the EGTP (Evolved GPRS Tunnel Protocal) service by following the configuration
example in the section
example in the section
Configuring the Egress Context and EGTP Service
Use the following configuration example to configure thegress context, the EGTP (Evolved GPRS Tunnel Protocal)
service, the S2b interface and S2b loopback interface to the P-GW, and bind all of the logical interfaces to the physical
Ethernet ports.
service, the S2b interface and S2b loopback interface to the P-GW, and bind all of the logical interfaces to the physical
Ethernet ports.
configure
context <egress_context_name>
interface <s2b_interface_name>
ipv4/ipv6 address <ipv6_address>
exit
interface <s2b_loopback_interface_name>
ipv4/ipv6 address <ipv6_address>
exit
subscriber default
exit
aaa group default
exit
gtpp group default
exit
gtpu-service <gtpu-service-name>
reg-lifetime <seconds>
bind ipv4/ipv6-address <s2bloopbackipv4/ipv6_address>
exit